Art.-No.: JA060400

Flow monitor for 1...8", mechanical, adjustable, for aggressive media, reduced switching values, Toggler, 24-230 VAC, 15(8)A

Flow monitoring of liquid media in pipes from 1/2" to 8", for example, oil, cooling and lubricant circuits or as safety against a shortage of water.

Assembly: Vertical in a horizontal pipe. Calming path at least 5 times the pipe diameter before and after the paddle.*
The max. flow can be significantly higher than the maximum setting value of the monitor.

Not approved for drinking water applications.

Technical Data:

Dimensions of housing:130 x 71 x 67 mm
Number of outputs:2
Output signal:switching
Output signal:switching
Configuration:reduced switching values
Rated impulse voltage:4000 V
Operating voltage:none
setting range:The setting and control range depend on the pipe diameter (see the table of switching values in the assembly instructions)
Electrical connection:Screw-type terminals
Colour of housing:grey (lower part like RAL 7016, upper part like RAL 7035)
Sensor:Flow paddle
Function type:Monitors
Accuracy:+/- 15% of the set value
Weight:ca. 900
Hysteresis:depends on the pipe diameter (see the table of switching values in the assembly instructions)
Internal setting:yes
Storage temperature:-40...85°C
Scope of supply:Flow monitor, paddle set
Material of housing:Plastic
Material of paddle:Special steel
Material of carrier:V4A
max. pressure:5 bar
max. switching voltage:230 VAC, 50 Hz
max. switching current:15 (8) A
Medium:Fluid, aggressive
min. switching voltage:24 VAC, 50 Hz
min. switching current:150 mA at 24 VAC, 50 Hz
Installation/fastening:by means of tapered Whitworth pipe thread R1"
Surface quality:matt
Test mark/Approbation:type-tested by the TÜV according to the VdTÜV circular "Flow 100" Component identification no. TÜV S. 04-017
Control function:switches if the set value undershot or exceeded
Pipe diameter:1...8"
Switching element:Microswitch
Switching contact:Changeover
Switching power:3450 W
Degree of protection:IP 65
Protection class:I
Safety and EMC:according to DIN EN 60730
Flow of liquid media:yes
Ambient temperature up to:85
Ambient temperature from:-40
Degree of fouling:II
permissible medium temperature:120°C
Permissible atmospheric humidity:max. 95% r.h., non-condensing
Ciruit Diagram: